Neil Webb

Whole point of programmable should be exactly that, not supplied at a fixed rate. I purchased the additional programmer to be able to set it wherever I needed. Unfortunately this is where the problems now lie.😪

Yes ive been through all this exactly as you have put, mine goes red and logs an error message at the read stage and goes red. I've tried a desktop Windows 10, laptop windows 10, tablet running windows 8 same thing happens on all. I've even tried different leads to no avail. Think either the servo or programmer not working as they should. I'm returning both to component shop and asking them to set it to 4 turns, replace as necessary.

I've just purchased the SW22HV and programmer. Eventually got the software to work but all I get is ERROR when I try to read or write to the servo. Mine is currently 1.5 turns and can crank up to 2.25 using end point adjustments. Need it to be 3.5 with the 30mm wheel. Any help...... please PS the helpful response I had from component shop was a link to same as in thus thread not from their site and it doesn't work on anything above windows 10. I've tried on windows 10 and 8 same happens. I think programmer is dodgy...thoughts?